Quote
"The present paper attempts to develop structural fibered foamed concrete (SFFC) with 10–70 MPa [1,500-7,300 psi] compressive strength and 1000–1900 kg/m³ [62-119 lb/ft³] density."
F
Foam concrete"Even foamed concrete with a compressive strength of 70 MPa can be made by the addition of polypropylene fiber and fine and used in high-performance cement..."
Foam concrete, also known as lightweight cellular concrete (LCC) and low density cellular concrete (LDCC), and by other names, is defined as a cement-based slurry, with a minimum of 20% foam entrained into the plastic mortar. As mostly no coarse aggregate is used for production of foam concrete the correct term would be called mortar instead of concrete; it may be called "foamed cement" as well. T
"The present paper attempts to develop structural fibered foamed concrete (SFFC) with 10–70 MPa [1,500-7,300 psi] compressive strength and 1000–1900 kg/m³ [62-119 lb/ft³] density."
"Foamed concrete (FC) is classified as lightweight concrete with a density ranging from 280 to 1800 kg/m³... and with a minimum of 20% of air pore volume in the cementitious mix..."
"To increase FC’s mechanical characteristics, the water-binding ratio w/b is usually maximally reduced, as well as the use of finely dispersed ic raw materials as a replacement for fine aggregate..."
"Except for some papers... the developed FRFC has a 28-day tensile and compressive strength not even more than 2.5 MPa and 50 MPa, respectively."
"Fibre-reinforced foam concrete mixture is poured into molds without mechanical compaction, so it must have self-sealing ."
"Practically, a sufficient flow range in a premixed paste is a proof of the effective production of FC. When the value of flow seen was lesser than the limit, the mixes of the developed premixed paste and foam was considered in-cohesive. The binders seemed to be covered by air bubbles, which collapsed afterwards. [W]hen the value of flow was greater than the limit, seclusion happened and foam bubbles inclined to collapse."